Omron E5AR-T User Manual page 100

Continue
Parameter (See note
Elapsed Program/ Held
Segment Time
Program Repetitions Held
Hold Status Held
Auto/Manual Held
Manual MV Held
(See note 3.)
Run/Reset Held
Note1: Including "Ramp Back."
2: If a PV start causes an invalid period, time will be considered to
have elapsed for the invalid period.
The elapsed program and segment timers will operate as
outlined below when "Ramp Back" has been set for the
Operation at Power ON parameter:
• If power is interrupted while soaking, the timer will stop until
the present SP returns to the segment SP.
• If power is interrupted during ramp operation, the timer is
restarted using the PV immediately after power is restored as
the PV when power was interrupted.
3: For the Standard Models in Manual Mode at the power inter-
ruption.
4: If power is interrupted in Auto Mode, the value set for the MV at
Reset parameter will be output, unless the Manual Output
Method parameter is set to "Output Initial Value." If the Manual
Output Method parameter is set to "Output Initial Value," the
value set for the Manual MV Initial Value parameter will be
output.
5: For coordinated operation, the channel 1 values for the
Program No., Segment No., Elapsed Program Time, Elapsed
Segment Time, Program Repetitions, and Hold Status param-
eters will be used for the other channels.
• The default setting for the Operation at Power ON parameter
is "Continue."
• Set the Operation at Power ON parameter for each channel.
• If the control mode is set to cascade control, set the
Operation at Power ON parameter for channel 2.
• The operation when the Operation at Power ON parameter is set to
"Ramp Back" is described below.
4.12 Starting and Stopping Operation
Reset Manual
1.)
--- Held
--- Held
--- Held
Held ---
Held Held
(See note 4.)
--- Held
Run
---
---
---
Held
Held
---
4-43