Parameter Initialization - Omron E5AR-T User Manual

Response

■ Parameter Initialization

Command
Response
Related
information
Ch
H'F0
All
H'F1
Use this command to select automatic or manual operation.
This command is used in setting area 0. If used in setting area 1, an
operation error will result.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
When the control mode is set to cascade control, perform the Auto/
Manual operation command for channel 2.
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'09
1 1 2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
Slave Function Write start Operation
address code address code information
H'06 H'00 H'00 H'0B
1 1 2
This command returns all settings to the default settings.
This command is used in setting area 1. If used in setting area 0, an
operation error will result.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'0B
1 1 2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
7.9 Commands and Responses
Description
Command mode
Auto
Manual
Related
CRC-16
information
2 2
Related
CRC-16
H'00
2 2
Related
information CRC-16
H'00
2 2
7-31