Omron E5AR-T User Manual page 99

Section 4 Settings Required for Basic Control
● Operation at Power
ON
4-42
Note1: The program moves into Program SP Mode and program
operation starts from the fixed SP.
2: Control does not stop. Control is executed for the fixed SP.
(The program moves into Fixed SP Mode.) Control is executed
for the remote SP when the program moves into Remote SP
Mode.
• If the Operation at Reset parameter is set to "fixed control," the first
segment will become a ramp segment.
• The following table shows example settings.
Segment No.
Segment SP
Segment Time
(h:min)
SP
Segment 1
100.0
50.0
FSP
• This parameter determines the operating status when the power to
the E5AR-T/ER-T is turned ON. The following 5 selections are
possible.
Setting
The status of the system before the power was
Continue
turned OFF is resumed.
Control is always reset status when the power is
Reset
turned ON.
Manual Mode is entered when the power is turned
Manual Mode
ON.
The program is always executed from the begin-
Run
ning when the power is turned ON.
The SP starts from the present value when the
Ramp back power is turned ON and ramp operation is per-
formed with the previous ramp slope.
• The following table shows what values are held depending on the
Operation at Power ON parameter setting.
Continue
Parameter (See note
1.)
Program No. Held
Segment No. Held
1 2
100.0 100.0 50.0
8:00 10:00 5:00
Segment 3
Segment 2
8:00 10:00 5:00
Time (h:min)
Operation
Reset Manual
Held Held
--- Held
3 ---
---
---
Run
Held
---