Omron E5AR-T User Manual page 332

CH
Operation at Power ON
Function
Setting
Reference
Reference
CH
End Condition
Function
Setting
Reference
Reference
8.18 Expansion Control Setting Level (l.exc)
p-on
• Select "Continue," "Reset," "Manual Mode," "Run Status," or "Ramp
Back" for operation after the power is turned ON.
• Operation after a software reset or when moving from the Initial
Setting Level to the Operation Level is also determined by this
parameter.
Setting range
cont: Continue
rst: Reset
manu: Manual Mode
run: Run Status
rmpb: Ramp Back
● Related Information
4.12 Starting and Stopping Operation (P. 4-41)
eset
This parameter is used to specify the operation status after the
program has been completed.
• Reset: Operation ends
• Continue: Operation is continued using the SP of the last
segment.
The number of the last segment is held as the
segment number, and the elapsed program time,
elapsed segment time, and remaining segment
time values are held. The time singles will hold
status when operation ends.
• Fixed SP Mode: Operation continues in Fixed SP Mode when the
program has been completed.
The segment number, elapsed program time,
elapsed segment time, and remaining segment
time are held at the values for the beginning of the
segment.
The Time Signal parameter is set to OFF.
Setting range
rst: Reset Status
cont: Continue
fsp: Fixed SP Mode
● Related Information
End Condition in 5.7 Program Operation Functions (P. 5-38)
Unit Default value
cont: Continue
Unit Default value
rst: Reset Status
l.exc
l.exc
8-95