Advance - Omron E5AR-T User Manual

Section 7 Modbus Communications
Response

■ Advance

Command
Response
7-34
Operation errors will also occur in the following cases:
• If AT is being executed
• If the specified channel is being reset or is on standby
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'12
1 1 2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'13
1 1 2
Related
information
Ch
"00" 1
"10" 2
"20" 3
"30" 4
"F0" All
This command executes an advance operation. Operation will move to
the beginning of the next segment.
This command is used in setting area 0. An operation error will occur if
it is used in setting area 1.
Operation errors will also occur in the following cases:
• If AT is being executed
• If the specified channel is being reset or is on standby
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
Slave Function Write start Operation
address code address code
H'06 H'00 H'00 H'13
1 1 2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
Related
information CRC-16
2 2
Related
information CRC-16
2 2
Description
Command mode
Advance
Advance
Advance
Advance
Advance
Related
information CRC-16
2 2