Omron E5AR-T User Manual page 246

CH
Present Value (PV)/Present Set Point
Function
Setting
Reference
Reference
• Display No. 1 shows the PV and Display No. 2 shows the present set
point.
• The Program SP, Fixed SP, or the Remote SP is shown depending
on the selected SP mode. For a Remote SP, the value can only be
monitored.
Program SP or Remote SP Mode
SUB1 SUB2 SUB3 SUB4 WAIT FSP
Present value (PV)
3 8.8
.
1
CH
Monitor only
156.0
.
Program No.
01.01
Segment No.
CMW MANU
OUT1 OUT2 OUT3 OUT4 RST RSP HOLD
PF1 PF PF2
RUN/ UN/ RST
E5AR
• The decimal point position is determined by the selected sensor for
a temperature input, and by scaling for an analog input. If the PV
Decimal Point Display parameter is set to "OFF" for a temperature
input, digits below the decimal point are not shown.
Monitor range
Refer to Appendix Sensor Input Set-
PV ting Ranges and Display/Control
Ranges (P. A-4)
Setting or monitor range
Program SP or Fixed SP: SP lower
limit to SP upper limit
Present
Remote SP: Remote SP lower limit to
Set Point
remote SP upper limit
The SP limits are in effect.
● Related Parameters
Input * Type (Input Initial Setting Level) (P. 8-50)
Input* Temperature Units (Input Initial Setting Level) (P. 8-51)
Scaling Input Value 1, Scaling Display Value 1, Scaling Input Value
2, Scaling Display Value 2, and Decimal Point Position (Input Initial
Setting Level) (P. 8-51)
Remote SP Upper Limit and Remote SP Lower Limit (Input Initial
Setting Level) (P. 8-52)
PV Decimal Point Display (Input Initial Setting Level) (P. 8-53)
SP Upper Limit and SP Lower Limit (Control Initial Setting Level) (P.
8-57)
SP Mode (Adjustment Level) (P. 8-24)
8.3 Operation Level ( )
PRG.SEG
Fixed SP Mode
FSP indicator flashes
SUB1 SUB2 SUB3 SUB4 WAIT FSP
Present value (PV)
38.8
.
1
CH
Fixed SP
156.0
..
Program No.
01.01
.
Segment No.
CMW MANU
OUT1 OUT2 OUT3 OUT4 RST RSP HOLD
PF PF1 PF2
RUN/ UN/ RST
E5AR
Unit
EU
Unit Default value
EU 0
EU -
8-9