Section 6 CompoWay/F Communications
Response
■ Parameter Initialization
Command
Response
6-32
Related
information
Ch
"10"
2
"11"
"20"
3
"21"
"30"
4
"31"
"F0"
All
"F1"
Use this command to select automatic or manual operation.
This command is used in setting area 0. An operating error will occur if
it is used in setting area 1.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC
SRC
Response code
"30"
"05"
"0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction
Related
MRC
SRC
code
information
"30"
"05"
"0B"
"00"
This command returns all settings to the default settings.
This command is used in setting area 1. An operating error will occur if
it is used in setting area 0.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC
SRC
Response code
"30"
"05"
"0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Description
Operation mode
Auto
Manual
Auto
Manual
Auto
Manual
Auto
Manual