Settings - Omron E5AR-T User Manual

Section 4 Settings Required for Basic Control

■ Settings

◆ "Run/Reset Selected for the PF1 Setting or PF2 Setting Parameter
1 25.0
0.0
01.01
◆ "Run/Reset" Not Selected for the PF1 Setting or PF2 Setting Parameter
1 25.0
0.0
01.01
1 r-r
run
01.01
1 r-r
rst
01.01
4-46
The following procedure is used to stop program operation.
1. Press the PF Key for which Run/Reset has been specified for at least 1
second. The RST indicator will light and the program will stop.
To start operation again, press the same PF Key for at least 1 second
again. The RST indicator will turn OFF and the program will start operation.
(1) Press the M Key several times to select r-r: Run/Reset.
(2) Press the U Key to switch to rst: Reset. The RST indicator will light and
the program will stop.
To restart the program, use the same procedure to switch to run:
Run. The RST indicator will turn OFF and the program will start.
Switching between run and reset is also possible using an
event input or communications.
Hint
For event inputs, refer to 5.8 Using Event Inputs (P. 5-39).
For communications, refer to 5.10 Using Communications
(P. 5-49).