■ Run/Reset
Command
Response
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
Slave
Function
Write start
Operation
address
code
address
code
H'06
H'00
H'00
H'01
1
1
2
Description
Related
information
Ch
H'00
1
H'01
H'10
2
H'11
H'20
3
H'21
H'30
4
H'31
H'F0
All
H'F1
This command is used to start or reset control.
This command is used in setting area 0.
When the control mode is set to cascade control, perform the Run/
Reset operation command for channel 2.
If "All" is selected for the channel, only the channels that are enabled
will be affected by this command.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
Slave
Function
Write start
Operation
address
code
address
code
H'06
H'00
H'00
H'01
1
1
2
The response for a normal end is shown above. For information on
error responses, refer to 7.7 Operation Commands (P. 7-15).
7.9 Commands and Responses
Related
information
CRC-16
2
2
Control state
Run
Reset
Run
Reset
Run
Reset
Run
Reset
Run
Reset
Related
information
CRC-16
2
2
7-25