Save Ram Data; Software Reset; Move To Setting Area 1 - Omron E5AR-T User Manual

Section 6 CompoWay/F Communications

■ Save RAM Data

Command
Response

■ Software Reset

Command
Response

■ Move to Setting Area 1

Command
6-30
Instruction Related
MRC SRC
code information
"30" "05" "05" "00"
This command writes the set values in the Operation Level, Program
Setting Level, Adjustment Level, Adjustment 2 Level, Alarm Set
Setting Level, PID Setting Level, Time Signal Setting Level, and
Approximation Setting Level to EEPROM. For information on these
levels, refer to 4.1 Setting Levels and Key Operations (P. 4-2).
This command can be used in both setting area 0 and setting area 1.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC SRC
Response code
"30" "05" "0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction Related
MRC SRC code information
"30" "05" "06" "00"
A software reset causes the same operation as turning the power OFF
and ON.
This command can be used in both setting area 0 and setting area 1.
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC SRC
Response code
"30" "05" "0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction Related
MRC SRC code information
"30" "05" "07" "00"
Use this command to move to setting area 1.