Omron E5AR-T User Manual page 173

Section 6 CompoWay/F Communications
*1: Executed for all channels.
*2: Specify the channel.
0: CH1, 1: CH2, 2: CH3, 3: CH4, F: All channels
Note: When all channels is specified, only enabled channels will respond and processing will begin from
channel 1. If an error is detected on any one channel, an operation error will occur. If all channels
end normally, a normal end will occur.
Important
Response
6-14
When cascade control is selected for the control mode, specify channel 2 commands
for the following operation commands:
• Run/Reset
• Auto/Manual
• SP Mode
• Cascade Open/Close
FINS-mini Response Text
Response code
MRC SRC
(MRES/SRES)
"30" "05"
2 2
Data name
MRC/SRC
Response code
Response Codes
Response
code
Command length
"1001"
too long
Command length
"1002"
too short
Parameter error
"1100"
"2203" Operation error
"0000" Normal end
4
Description
FINS-mini command text is returned here.
Result of execution of the command.
Error name
The command is too long.
The command is too short.
Operation code or related information is
not correct.
• Unable to execute because the
communications writing function is
disabled.
• Unable to execute operation
command. For more information, refer
to corresponding operation command
description in 6.9 Commands and
Responses.
• Unit error, unit change, display unit
error, or EEPROM error.
---
Description