Omron E5AR-T User Manual page 319

Section 8 Parameters
Display Auto-return Time
Function
Setting
Display Refresh Period
Function
Setting
Monitor Item Level Setting
Function
Setting
8-82
ret
• This parameter is used to select the amount of time without key
operation that must elapse for the display to revert to the Present
Value (PV)/Preset Set Point display when in Operation Level,
Program Setting Level, Adjustment Level, Adjustment 2 Level, Alarm
Set Setting Level, PID Setting Level, Time Signal Setting Level,
Approximation Setting Level, or Monitor Item Level.
• When 0 is selected, the function is disabled (no auto reset).
Setting range
0 to 99
d.ref
• This parameter is used to lengthen the refresh period of the monitor
value display. This only slows the display refresh cycle; it does not
affect the update period of the PV during control.
• To disable the function, select OFF.
Setting range
off, 0.5, 1, 2, 4
monl
• One of the following levels can be selected as the Monitor Item Level
setting: Input Initial Setting Level, Control Initial Setting Level,
Control Initial Setting 2 Level, Alarm Setting Level, Display
Adjustment Level, Communications Setting Level, Advanced
Function Setting Level, and Expansion Control Setting Level.
• The Monitor Item Level is added after the Approximation Setting
Level.
• When OFF is selected, the function is disabled (i.e., the Monitor Item
Level is disabled).
Setting range
off:
Monitor Item Level disabled.
l.0:
Input Initial Setting Level
l.1:
Control Initial Setting Level
l.2:
Control Initial Setting 2 Level
l.3:
Alarm Setting Level
l.4:
Display Adjustment Level
l.5:
Communications Setting Level
l.adf: Advanced Function Setting Level
l.exc: Expansion Control Setting Level
l.4
Unit Default value
s 0
l.4
Unit Default value
s 0.5
l.4
Unit Default value
off