Changing Channels - Omron E5AR-T User Manual

Section 4 Settings Required for Basic Control

4.14 Changing Channels

■ Changing Channels

Present value (PV) / SP
.
8.8. 2 . 5.0
1
CH
8.8.8.0.0
01.01
OUT1 OUT2 OUT3 OUT4 RST RSP
PF1 PF 2
RUN/RST
key
CH
● Level after
Changing
Channels
● Displayed
Parameter after
Changing
Channels
4-50
• On Controllers with more than one input, the channel number
increases by 1 each time the
channel changes accordingly.
PV
• Only channels that are enabled with the Number of Enabled
Channels parameter can be displayed.
SV
PRG.
• If the Number of Enabled Channels parameter is set to 2 on a 4-
SEG
point input type, the display will switch through the channels as
HOLD
follows each time the
Channel 1 Channel 2
• When changing channels, the level will remain the same as the level
currently being displayed.
• When a Manual Mode channel is selected, the display will show the
manual operation display in the Operation Level.
• The displayed parameter after changing channels is as follows:
1. If the parameter that is currently being displayed will continue to
be displayed if it is enabled for the new channel.
2. If the parameter that is currently being displayed is not enabled
for the new channel because the control method is different or for
any other reason, the next enabled parameter will be displayed.
The following is an example of changing channels in the Operation
Level.
Present Value (PV)/SP
25.0
1
CH
The CH key is disabled on
models with only one channel.
Hint
Key is pressed and the displayed
CH
Key is pressed:
CH
Channel 1
Present Value (PV)/SP
2
CH
key
CH
0.0
01.01
Parameter for selected channel
appears.
If you continue to hold down the
channels, you will not move to the next channel. To con-
tinue changing channels, release and press the
again.
For more information, refer to 5.4 Display and Key Adjust-
ment Functions (P. 5-18).
Channel 2...
15
0.0
0.0
01.01
Key after changing
CH
Key
CH