Omron E5AR-T User Manual page 295

Section 8 Parameters
Control Mode
Function
Setting
Reference
Reference
CH
Direct/Reverse Operation
Function
Setting
Reference
Reference
8-58
mode
Use this parameter to select the control mode.
• On single-input or 4-input Controller Models, select standard control
or heating/cooling control.
• On two-input Controller Models, select standard control, heating/
cooling control, standard control with remote SP, heating/cooling
control with remote SP, proportional control, cascade standard
control, or cascade heating/cooling control.
Setting range
0: Standard
1: Heating/cooling
2: Remote SP standard
3: Remote SP heating/cooling
4: Proportional
5: Cascade standard
6: Cascade heating/cooling
The setting range is 0 or 1 on a single- or 4-input Controller Model and
0 to 6 on a 2-input Controller Model.
● Related Information
4.6 Selecting the Control Mode (P. 4-15)
● Related Parameters
Control/Transfer Output
Level) (P. 8-64)
orev
• When direct operation is selected, the MV is increased when the PV
increases. When reverse operation is selected, the MV is increased
when the PV decreases.
Setting range
or-r: Reverse operation
or-d: Direct operation
● Related Information
Direct Operation (Cooling)/Reverse Operation (Heating) in 4.7
Setting Output Parameters (P. 4-20)
Unit Default value
0
Assignment (Control Initial Setting 2
Unit Default value
or-r: Reverse operation
l.1
l.1