Section 6 CompoWay/F Communications
Response
■ AT Cancel
Command
Response
■ Write Mode
Command
6-28
MRC
SRC
Response code
"30"
"05"
"0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction
Related
MRC
SRC
code
information
"30"
"05"
"0A"
Related
information
Ch
"00"
1
"10"
2
"20"
3
"30"
4
"F0"
All
This command cancels AT.
This command is used in setting area 0. An operating error will occur if
it is used in setting area 1. An operation error will also occur in the
following cases:
• If the Run/Reset parameter is set to "Reset" for the
specified channel
• If the Auto/Manual parameter is set to "Manual" for the
specified channel
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC
SRC
Response code
"30"
"05"
"0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
Instruction
Related
MRC
SRC
code
information
"30"
"05"
"04"
Related
Description
information
"00"
Backup Mode
"01"
RAM Write Mode
Description
Operation
AT Cancel
AT Cancel
AT Cancel
AT Cancel
AT Cancel