Hold - Omron E5AR-T User Manual

Programmable digital controller

Hide thumbs Also See for E5AR-T:

Table of Contents

Section 6 CompoWay/F Communications

■ Hold

Use this command to select the SP Mode. Refer to SP Modes in 5.7

Program Operation Functions (P. 5-31) for details on the SP Mode.

This command can be used in both setting area 0 and setting area 1.

• If AT is being run in the specified channel, an operation error will

To use this command, the communications writing function must be

enabled using the Communications Writing operation command.

Response code

Response Codes:

The response for a normal end is shown above. For the

response codes, refer to 6.7 Operation Commands (P. 6-13).

Command mode

Command mode