Omron E5AR-T User Manual page 121

Section 5 Functions and Operations
(2) Coordinated
Operation
● Models with Four
Inputs
5-12
• Coordinated operation based on
channel 1 is possible when the
Independent Operation/Coordi-
nated Operation parameter is set
to "Coordinated Operation." The
program will be the same for both
channel 1 and channel 2.
• As shown in the diagram on the
right, coordinated operation
enabled when the channel 1
program pattern is input to the
channel 2 remote SP.
• The present SP or the PV can be
set as the program pattern from
channel 1. If the PV is set and
channel 1 has an input error, an RSP input error will occur for
channel 2.
• An offset can be set for channel 2.
• Any change in the Run/Reset parameter selection for channel 1 will
also be changed for channel 2. The channel 2 Run/Reset parameter
can, however, be set independently.
• Advance, hold, and back segment operations will be executed for
both channels.
• Coordinated operation based on
channel 1 is possible. The program
will be the same, therefore, for all
channels.
• As shown in the diagram on the
right, coordinated operation
enabled when the
program pattern is input to the remote SP for channels 2 to 4.
The present SP or the PV can be set as the program pattern from
channel 1. If the PV is set and channel 1 has an input error, an RSP
input error will occur for channels 2 to 4.
• Any change in the Run/Reset parameter selection for channel 1 will
also be changed for channels 2 to 4. Each Run/Reset parameter for
channels 2 to 4 can, however, be set independently.
• Advance, hold, and back segment operations will be executed for all
channels.
Present
Channel 1
Set Point
or PV
RSP
Channel 2
is
Temperature
SP Offset
Channel 1
Channel 3
Channel 2
is
Offset can be set for channels 2 to 4.
channel 1
SP offset
CH2
CH1
Time
Present Set
Point or PV
RSP
Channel 4