Omron E5AR-T User Manual page 297

Section 8 Parameters
Number of Segments
Function
Setting
Program Time Unit
Function
Setting
Step Time/Rate of Rise Programming
Function
Setting
Reference
Reference
8-60
snum
• This parameter is used to set the maximum number of segments
that can be set in a program. The default value is 16.
Setting range
8, 12, 16, 20, or 32
t-u
• This parameter is used to specify the time unit for the program.
• The Program Time Unit parameter specifies the time unit for the
following parameters. The Program Time Unit parameter must be
set before the following parameters can be set.
• Segment Time
• Time Signal ON Time and Time Signal OFF Time parameters
Setting range
hhmm
: Hours, minutes
nnss
: Minutes, seconds
nnssd
: Minutes,
seconds, deciseconds
t-pr
• This parameter is used to specify the programming method.
Setting range
time
: Step Time
pr
: Rate of Rise Programming
● Related Information
Rate of Rise Programming in 5.7 Program Operation Functions (P.
5-28)
Unit Default value
16
Unit Default value
hhmm
: hours, minutes
Unit Default value
time
: Step Time
l.1
l.1
l.1