Omron E5AR-T User Manual page 10

● Special Notation
(1) Important
"Important" appears where incorrect settings or operation will prevent a function from
achieving the expected result.
(2) Hint
"Hint" gives useful hints, advice, and other supplemental information.
(3) Notation used to indicate various information on parameters ("Function," "Setting,"
● Abbreviations
Abbreviations used in the parameters, illustrations, and text are listed in the
following table.
Abbreviation
* Data after scaling is shown in engineering units such as °C, m, and g. "EU" is used
to indicate the minimum increment of such a quantity. For example, the minimum
increment of 50.02 m is 0.01 m, and thus 1 EU would be equal to 0.01 m.
● Notation Used for Settings
Letters, numbers, and abbreviations in settings that appear on the E5AR-T/ER-T
display are as follows:
a
A
n
N
0
0
Set the input type before setting the scaling value.
If the input type is changed after setting the scaling value, the scal-
Important
ing value will be automatically initialized.
Overshooting can be adjusted using the external interference over-
shoot adjustment function when there is excessive overshooting in
Hint
temperature control (i.e., in response to external interference).
"Monitor," and "Reference") are explained in Section 8 Parameters.
Meaning
PV Present value
SP Set point
SV Set value
AT Auto-tuning
EU Engineering units*
b c d e
B C D E
o p q r
O P Q R
1 2 3 4
1 2 3 4
Abbreviation
ch
CH
PSP
RSP
FSP
f g h i
F G H I
s t u v
S T U V
5 6 7 8
5 6 7 8
Meaning
Channel
Channel
Program SP
Remote SP
Fixed SP
j k l m
J K L M
w x y z
W X Y Z
9
1
-
9 -1 (Most signif-
icant digit)
IX