Reading Set Values - Omron E5AR-T User Manual

■ Reading Set Values

Command
Slave Function Read start Number of
address code address elements
H'03
1 1 2
Address
H'0600 to 061C
H'0700 to 074A
H'0800 to 0818
H'0900 to 096E
H'0A00 to 0A9E
H'0B00 to 0B6E
H'1800 to 183A
H'1900 to 196C
H'0C00 to 0C20
H'0D00 to 0D36
H'0E00 to 0E76
H'0F00 to 0F2C
H'1000 to 100E
H'1100 to 110C
H'1200 to 1218
H'1300 to 133A
H'4000 added to above
addresses
H'8000 added to above
addresses
H'C000 added to above
addresses
This command is used to read set values. The number of elements
can be set from H'0004 to 006A (4 to 106) to allow successive reading
of 2 to 53 set values in consecutive addresses.
To specify the variable type or address, refer to Appendix Setting Lists
(P. A-6). The upper limit of an address depends on the variable type.
This command can be used in both setting area 0 and setting area 1.
When used in setting area 1, the response for the remote SP monitor,
ramp SP monitor, and valve opening monitor will be 0 and the
response for the status will be as indicated in the notes in E5@R-T
Status (Communications) in Appendix Setting Lists (P. A-8).
7.9 Commands and Responses
CRC-16
2 2
Description
Ch
Set values in setting area 0
Operation Level
Adjustment Level
Adjustment 2 Level
Alarm Set Setting Level
PID Setting Level
Approximation Setting Level
Program Setting Level
Time Signal Setting Level
1
Set values in setting area 1
Input Initial Setting Level
Control Initial Setting Level
Control Initial Setting 2 Level
Alarm Setting Level
Display Adjustment Level
Communications Setting Level
Advanced Function Setting Level
Expansion Control Setting Level
2 Same set values as channel 1
3 Same set values as channel 1
4 Same set values as channel 1
7-21