Back; Controller Attribute Read - Omron E5AR-T User Manual

Section 6 CompoWay/F Communications

■ Back

Command
Response

■ Controller Attribute Read

Command
Response
6-36
Instruction Related
MRC SRC code information
"30" "05" "14"
Related
information
Ch
"00" 1
"10" 2
"20" 3
"30" 4
"F0" All
This command executes a back operation. Operation will move to the
beginning of the current segment.
This command is used in setting area 0. An operation error will occur if
it is used is setting area 1.
Operation errors will also occur in the following cases:
• If AT is being executed
• If the specified channel is being reset or is on standby
To use this command, the communications writing function must be
enabled using the Communications Writing operation command.
MRC SRC Response code
" 30" "05" " 0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.7 Operation Commands (P. 6-13).
MRC SRC
"05" "03"
This command reads the E5AR-T/ER-T model number and communi-
cations buffer size. The command can be used in any state of the
E5AR-T/ER-T.
SRC
MRC Response code
"05" "03" "0000"
Response Codes:
The response for a normal end is shown above. For the
response codes, refer to 6.5 Read from Variable Area (P. 6-10).
Description
Command mode
Back
Back
Back
Back
Back
Format Buffer size
"00D9"