Omron E5AR-T User Manual page 247

Section 8 Parameters
CH
Program No.
Function
Setting
Reference
Reference
CH
Hold
Function
Operation
Reference
Reference
8-10
prg
• This parameter sets the number of the program to be executed.
• This parameter can be set only during a reset.
Setting or monitor range
1 to 32 (See note.)
Note:The range depends on the values set for the Independent
Operation/Coordinated Operation parameter and Number of
Segments parameter.
● Related Parameters
Independent Operation/Coordinated
Setting Level) (P. 8-59)
Number of Segments (Control Initial Setting Level) (P. 8-60)
hold
• This parameter is used to hold the timer for program operation.
• The hold is cleared by executing a reset or executing a clear hold
command.
• The hold is enabled when this parameter is set to
off
• The default is : Clear Hold.
● Related Information
5.7 Program Operation Functions (P. 5-28)
Unit Default value
--- 1
Operation (Control Initial
Running
on
.