Omron E5AR-T User Manual page 281

Section 8 Parameters
CH
Program Editing
Function
Setting
Reference
Reference
CH
Time Signal * Set Segment 1
Time Signal * Set Segment 2
Time Signal * Set Segment 3
(*: 1 to 6)
Function
Setting
Reference
Reference
8-44
prg.n
• This parameter is used to set the program number of the program to
be set.
Setting range
1 to 32
Note: The current program number.
● Related Parameters
Auxiliary Output * Assignment (Control Initial Setting 2 Level) (P. 8-
67)
Program Output Selection (Control Initial Setting 2 Level) (P. 8-68)
tsg1.*
tsg2.*
tsg3.*
• Time signals can be set for 6 outputs for each program, with 3 time
signals for each output.
• This parameter is used to set the segments for which time signals
are used. The default setting is 0 (disabled).
Setting range
0 to Number of Segments (0: Disabled)
● Related Information
Time Signal in 5.7 Program Operation Functions (P. 5-33)
● Related Parameters
Auxiliary Output * Assignment (Control Initial Setting 2 Level) (P. 8-
67)
Program Output Selection (Control Initial Setting 2 Level) (P. 8-68)
Time Signal * ON Time * (Time Signal Setting Level) (P. 8-45)
Time Signal * OFF Time * (Time Signal Setting Level) (P. 8-45)
CH1 or CH2 during independent
operation with time signal enabled
Unit Default value
--- (See note.)
CH1 or CH2 (during independent
control) with time signal enabled
Unit Default value
--- 0: Disabled