Section 8 Parameters
CH
Open/Close Hysteresis
Function
Setting
Reference
Reference
CH
Standby Time
Function
Setting
Reference
Reference
8-28
oc-h
• This parameter is used to add hysteresis when switching the open
output and close output ON and OFF during position-proportional
control.
Data range
0.1 to 20.0
● Related Parameters
Position-proportional Dead Band (Adjustment Level) (P. 8-27)
stb
• This parameter is used to set the time from when the run command
is executed until the program starts operation.
Setting parameter
0.00 to 99.59
● Related Information
Operation at Program Start in 5.7 Program Operation Functions (P.
5-37)
Position-proportional Control Model
Unit
Default value
%
0.8
Unit
Default value
h.min
0.00
l.adj
l.adj