Omron E5AR-T User Manual page 305

Section 8 Parameters
Reference
Reference
Program Output Selection
Function
Setting
Reference
Reference
8-68
*1 The data that is output depends on the setting of the Program
Output Selection parameter and will be program output 1 to 10,
segment output 1 to 10, segment number output 1 to 6, or time
signal output 1 to 6.
*2 On a Controller with more than one input, assignment data can be
set for channels 2 and higher for the number of supported
channels. U-ALM output will be OR output of alarm functions 1 to 4
of all channels.
● Related Information
4.11 Using Auxiliary Outputs (P. 4-37)
● Related Parameters
Program Output Selection (Control Initial Setting 2 Level)
Opsot
"Program Output" assigned to Auxiliary Output
• This parameter is used to set what is output when "Program Output"
is selected for the Auxiliary Output Assignment parameter.
Setting range
sgo
: Segment Output
sgn
: Segment No. Output
tsg
: Time Signal
● Related Information
Time Signal in 5.7 Program Operation Functions (P. 5-33)
Segment Output in 5.7 Program Operation Functions (P. 5-34)
Program Status Outputs in 5.7 Program Operation Functions (P. 5-
36)
● Related Parameters
Auxiliary Output * Assignment (Control Initial Setting 2 Level) (P. 8-
67)
l.2
Unit Default value
sgo
: Segment
Output