Advertisement
Parameters
process-id
match external
match internal
route-map map-name
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
With FTOS version 8.3.1.0 and later, the redistribute command can be used to advertise the IGP cost as
Information
the MED
outbound to an EBGP peer/peer-group, the advertised routes corresponding to those peer/peer-group
will have IGP cost set as MED.
When you enter
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This feature is
not supported by an RFC.
Command
History
router bgp
c e s
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number
Defaults
Not enabled.
Command Modes
CONFIGURATION
Example
Figure 12-4. Command Example: router bgp
(conf)#router bgp 3
(conf-router_bgp)#
1
2
{
|
}
. When the route-map is set with metric-type internal and applied
on redistributed routes
redistribute isis
Version 8.3.1.0
Introduced ability to substitute IGP cost for MED when a peer/peer-group
outbound route-map is set as internal.
Version 7.8.1.0
Introduced support on S-Series
Version 7.7.1.0
Introduced support on C-Series
Enter the AS number.
Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte)
0.1-65535.65535 (Dotted format)
Enter the number of the OSPF process.
Range: 1 to 65535
(OPTIONAL) Enter the keywords match external to redistribute OSPF
external routes. You can specify 1 or 2 to redistribute those routes only.
(OPTIONAL) Enter the keywords
internal routes only.
(OPTIONAL) Enter the keywords
configured Route map.
process-id command without any other parameters, FTOS
match internal
to redistribute OSPF
route-map
followed by the name of a
or
Border Gateway Protocol IPv4 (BGPv4) | 365
Advertisement
