Purging The Dynamic Mac Address List - Siemens RX1500 User Manual

Chapter 5
Setup and Configuration
Figure 807: MAC Address Table
This table provides the following information:
Parameter
MAC Address
VLAN ID
Slot
Port
Type
CoS
If a MAC address is not listed, do the following:
• Configure the MAC address learning options to dynamically detect the MAC addresses of other devices on the
network. For more information, refer to
• Configure the address on the device as a static MAC address. For more information, refer to
"Adding a Static MAC
Section 5.33.2

Purging the Dynamic MAC Address List

To purge the dynamic MAC address list of all entries, do the following:
1. Navigate to switch » mac-tables and click purge-mac-table in the menu. The Trigger Action form
appears.
688
Description
The MAC address learned by the switch.
The VLAN identifier of the VLAN upon which the MAC address operates.
Synopsis: sm, lm1, lm2, lm3, lm4, lm5, lm6
The slot containing the module including the port.
The port on which the MAC address has been learned.
Synopsis: static, dynamic
How the MAC address has been learned by the switch:
• STATIC: The address has been learned as a result of static MAC address table
configuration or some other management activity and cannot be automatically unlearned
or relearned by the switch.
• DYNAMIC: The address has been automatically learned by the switch and can be
automatically unlearned.
Synopsis: N/A, normal, medium, high, crit
The Class Of Service (CoS) that is assigned to frames carrying this address as a source or
destination address.
Section 5.33.3, "Configuring MAC Address Learning
Address".
RUGGEDCOM ROX II
Options".
Section 5.33.4.2,
Purging the Dynamic MAC Address List
User Guide