Show Mac-Address-Table Dynamic Multicast - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.1 VLAN
The parameters have the following meaning:
Parameter
vlan
vlan-id
If you do not select any parameter from the parameter list, the total number of entries is
displayed for all VLANs.
Result
The number of MAC addresses for the selected VLAN is displayed.
6.1.1.3

show mac-address-table dynamic multicast

Description
This command shows the table with the dynamic multicast MAC addresses assigned by the
device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic multicast[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
address
aa:aa:aa:aa:aa:aa
interface
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
164
Description
Keyword for a VLAN connection
Number of the addressed VLAN
[address<aa:aa:aa:aa:aa:aa>]
[{interface<interface-type><interface-id>}]
Description
Keyword for a VLAN connection
Number of the addressed VLAN
Keyword for a MAC address
MAC address
Keyword for a an interface description
Type of interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
-
1 ... 4094
Range of values / note
-
1 ... 4094
-
-
-
Enter a valid interface
Configuration Manual, 07/2017, C79000-G8976-C361-06