Layer 2 management protocols
8.4 Ring redundancy and standby connection
Requirement
● The ports are disabled in spanning tree.
● You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
standby port {<interface-type> <interface-id>}
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The port for a standby connection is configured and enabled.
Further notes
You disable the setting with the no standby port command.
You can display the status of this function and other information with the show ring-
redundancy command.
8.4.6.9
no standby port
Description
With this command, disable the port for a standby connection on a device.
Requirement
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
406
Description
Type or speed of the interface
Module no. and port no. of the interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Enter a valid interface.
Configuration Manual, 07/2017, C79000-G8976-C361-06