Further notes
You disable the setting with the
You display the status of this function and other information
8.4.6.7
no standby port
Description
With this command, disable the port for a standby connection on a device.
Requirement
You are in the Redundancy configuration mode.
The command prompt is as follows:
cli(config-red)#
Syntax
Call up the command with the following parameters:
no standby port [<interface-type><interface-id>}
The parameters have the following meaning:
Parameter
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The ports for a standby connection are disabled.
Further notes
You enable the setting with the
You display the status of this function and other information
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
no standby port
Description
Type or speed of the interface
Module no. and port no. of the interface
command.
standby port
Layer 2 management protocols
8.4 Ring redundancy and standby connection
command.
show ring-redundancy
Range of values / note
Enter a valid interface.
show ring-redundancy
.
.
415