Countershaft Bearing
Replacement (cont'dl
Mainshaft Thrust Shim
Adjustment
1. Remove the thrust shim and oil guide plate from
the transmission housing.
otl GUIDE PLATE
rHnr rcr qHlM
Install the 3rd/4th synchro hub, spacer collars, sth
synchro hub, and ball bearing on the mainshaft,
then install the above assembly in the transmission
h o u s r n g .
lnstallthe washer on the mainshaft.
Measure distance @ between the end of the trans-
mission housing and washer.
NOTE:
a Use a straight edge and vernier caliper.
a Measure at three locations and average the read-
I n g .
END ot
TRANSMISSION
HOUSING
MAINSHAFT
WASHER
3RD/4TH SYNCHRO HUA
SPACER COLLAR
sTH SYNCHRO HUB
SPACER
lnstall the retaining plste and stake the bolt heads in
the groove in the retaining plate.
6 x 1 . 0 m m
12 N'm {1.2 kg-m,9lb-ftl
Replaco.
RETAINING PLATE
1 3 -3 4
BALL BEARING