Honda Prelude 1993 Service Manual page 831

Rear Suspension
Knuckle/Hub (cont'dl
CAUPER ARACKET MOUNTING BOLT
o .
7 .
Removal
1. Loosen the wheel nuts slightly.
2.
Raise the rear of car and support it with safety stands
in proper locations (see sectjon 1).
3.
Bemove the wheel lug nuts and rear wheel.
4.
Pull the parking brake lever up.
5. Remove the hub cap, then raise the locking tab on
the spindle nut, then remove the nut.
HUB CAP
Replace.
Remove the brake hose mounting bolts.
Remove the caliper bracket mounting bolts and hang
the caliper assembly to one side.
CAUTION: To prevent accidental damage to the
caliper assembly or brake hoss, use a shon pisce ot
wir€ to hang th€ calip€r as$mbly lrom th6 und6.-
cardag6.
BRAKE HOUSE MOUNTING BOLT
TRAILING ARM
NOTE| Take care not to damage the hub
18-28
CALIPER ASSEMBLY
8 .
9 .
Remove the 6 mm brake disc retaining screws
Screw two 8 x 1.25 mm bolts into the disc to push
it away from the hub.
NOTE: Turn each bolt two turns at time to prevent
cocking the disc excessively.
Remove the brake disc.
1 0 .
BRAKE OISC
5 MM EBAKE
RETAINIT{G S
1 1. Remove the hub unit from the knuckle,
I x 1.25 mm BOLTS
6 mm ERAKE DISC
RETAINIT{G SCREWS