Honda Prelude 1993 Service Manual page 213

14. lnstallthe balancar gea|. case to the oil pump.
NOTE: Align the groovo on the pulley sdg€ to the
pointor on the gear cass while holding ths rear bal-
ancer with 6 x 100 mm bolt, then install the gear
casg.
E x 1.25 mm
25 N.rn 12.5 lg.m.
18 rb-ft|
BALAI{CER
GEAR $SE
DOWEL PIN
O.RING
Apply engine oil,
Roplace.
Align the groov€
to pornter.
GROOVE
Check alignment of pointers after installing the gear
case.
POINTER ON THE PUL1TY
DOWEL PIN
POINTEB
16. Install the oil pan.
OIL PAN GASKET
Replace.
Apply liquid
gasket to here.
WASHER
Replace.
6 x l , 0 m m
12 N.m {1.2 kg.h,
9 rb-ft}
1 1 .
45 N.m (4.5 kg.m.
33 tb-ftt
Do not overtighten,
Tighten the bolts and nuts as shown below,
Torqu.: 12 N.m (1.2 kg-m, 9 lb.ft)
NOTE: Tighten the bolts and nuts in two stoos and
torque them in a criss-cross pattern.
7-29