Honda Prelude 1993 Service Manual page 181

23.
Remove the stopper.
ADJUSTER
P/N 14540-P't3-OO3
Make sure the crankshaft is positioned with the No. 1
cylinder at TDC.
Align the groove on the front balancer shaft pulley with
the pointer on the oil pump housing as shown.
6 r 100 mm BOLT
26. Align the rear balancer shsft pulley by using a 6 x 10O
mm bolt or equiv€lent as an alignment tool.
Scribe a line 74 mm (2.9 in) trom the end of th€ boh.
Insertthe bolt into the maintenanc€ holeto the scribsd
line.
27. Loosen the adjusting nut and verify that the timing
balancer belt adiuster moves freely.
28. Instsll the timing balancer belt. Remove the 6 x 10O
mm bolt trom the rear balsncer shsft.
29. Turn the crankshaft pulley about one turn, then tighten
the adjusting nut to the specified torque.
NOTE: Both belt adjusters are spring-loaded to
properlytension the belts. Do not apply any extra pros-
sure to the pulleys or tsnsioners while performing tha
adjustmenl.
REAR BALANCER SHAFT
12 mm SEALING BOLT
30 N.m {3.0 kg-m, 22lb-ft}
NOTE: Tighten the bolt after
installing the belt.
24.
25.
Align the groove of the
tront driven pulley with
the pointer on the oil
pump housing.
REAR TIMING BALANCER EELT
DRIVEN PULLEY
BALANCER BELT
(cont'dl
74 mm 12.9 in)
DRIVE PULLEY
Set the crsnkshaft at TDC.
6 - 1 1 3