Rocker Arms/Camshafts And Seals/Pulleys; Installation - Honda Prelude 1993 Service Manual

lnslall the intake manifold and tighten the nuts in a
criss-cross paltern in 2 or 3 steps. beginning with
the Inner nuts.
22 N.m (2.2 kg-m,
16 tb_ft}
4. Install the exhaust manifold and bracket. Tighten the
nuts in a criss-cross pattern in 2 or 3 steps, begin-
ning with the inner nuts.
Rocker Arms/Camshafts
and Seals/Pulleys
Installation
. Mak6 sura drat the keyways on th€ camdrafts a]€ fac-
krg up. (No. 1 r* on TDCI.
a Valv€ locknuts should b€ loosoned and boforo scrsws
backed off botoio installation.
a Replac€ the rocker arms in thsir origlnal positions,
1. Place the rocker arms on the pivot bolts and the valve
srems.
2. Install the camshafts and the camshalt seals with
the open side (spring) facing in.
3. Apply liquid gasket to the head mating surtaces of
the No.1 and No. 6 camshaft holders, then install
them, along with No. 2, 3. 4 and 5.
NOTE:
a "1" or "E' marks are stamped on the camshaft
holders.
a Do not apply oil to the holder mating surface of
camshaft seals.
a Apply liquid gasket to the shaded areas.
a The a.rows marked on the camshaft holders
should point toward the timing bett.
I x 1.25 mm
32 N.m {3.2 kg-m,
GASKET
Replace.
23 rb-ft)
I x 1 . 2 5 m m
22 N.m (2.2 kg-m,
16 rb-ft)
1 0 x 1 . 2 5 m m
45 N.m (4.5 kg-m,
^/'""1"'"1*"
l"'l
trBfr m ffi n
K g H H F H
N o . 2
/ N o .
1
,
_m*ll
Wi
TNTAKE
6r
&{ pI
LOJ
ffi 4.n**"
33 rb ft)
6 x 1 . 0 m m
1 O N . m ( 1 . O k g m ,
7 tb-tr)
M H
I l i H H
t r u
16r
M
liT
tl
GASKET
Replace.
HEAT INSULATOR
1 0 x 1 . 2 5 m m
55 N.m 15.5 kg,m, 40 lb,ft)
Replace.
{cont'd)
GASKET
8 r 1 . 2 5 m m
22 N.m (2.2 kg-m,
16 tb-ft)
ROCKER ARM
6 -5 7