Transmission Housing Bearings; Removal/Lnstallation - Honda Prelude 1993 Service Manual

Transmission Housing Bearings
Removal/lnstallation
1. To r€rnovs ths mainshait, countershsft and secondary
shaft bearings lrom the tranamission housing, expand
each snap ring with snap ring plisrs, thon push th€
bearing out.
NOTE:
Do not remove th€ snap rings unless it's necesaary to
cl€an the grooves in the housing.
I
Remov€
Expsnd €ach snap ring with snap ring pliers, ins
new b€aring part-way into it. then release the
Push the bearing down into the transmission u
ring snaps in placa around it,
NOTE:
Inst8ll with groove side o{ the housing facing ins
transmission housing.
lnstali
I
After installing th6 bosring verify the following:
. The snap ring ls se8ted in the bearing and hol
groovas.
. Th6 snap ring operates properly.
. Ths ring 6nd gap is correct.
P : 0 - 7 m m
(O-o.28 in)
SNAP RING
insert the
:he pliors.
I until the
inside the
housing
14-129