Honda Prelude 1993 Service Manual page 78

Cylinder Head
Removal (cont'd)
7 .
8 .
Remove the brake booster vacuum hose and vacu-
um hose mount (A/T only)from the intake manitold.
Remove the luel return hose and cruise control vacu-
um hose.
9.
Remove the throttle cable and the throttle control ca
bl; (A/T only) from the throttle body.
NOTE:
o Take care not to bend the cable when removing it.
Always replace any kinked cable with a new one.
a Adjust the throttle cable when installing (see sec-
tion 1 I ).
6 r 1 0 m m
1 2 N . m ( 1 . 2 k g - m , I l b - f t l
THROTTLE CONTROL
CABLE (A/T onlyl
CRUISE
r!: CORROSION RESISTANT BOLT
10. Removal the ignition coil.
* 8 x 1 . 2 5 m m
22 N.m (2.2 kg-m, 16lb-ftl
Remove the spark plug caps and the distributor,
Remove the connector and the te.minal from the alter-
nator, then remove the engine wire harness trom the
cylinder head cover.
Remove the following engine wire harness connectors
and clamps f.om the cylinder head and the intake
manitold:
a Four tuel injector connectors
o Intake air temDerature {lAT) sensor connector
o ldle air control (lAC) valve connector
. Throttle position (TP) sensor connector
o Exhaust gas recirculation (EGR) valve lift sensor
connector
. Ground cable terminals
. Engine coolant temperature (ECT) switch B con-
necror
o Heated oxygen sensor (HO25) connector
a ECT sensor connector
o ECT gauge sending unit connector
. lgnition coil conneclor
. CKP/TDC/CYP sensor connector
. Vehicle speed sensor (VSS) connector
a ECT switch A connector
1 2 .
1 3 .