Honda Prelude 1993 Service Manual page 161

Hide thumbs Also See for Prelude 1993:

Table of Contents

NOTE: Oo not rotate camshaft during inspection.

1. Remove the .ocker arms and rocker shafts,

NOTE; Rocker arms must be installed in the same po-

sition if reused.

fut the camshafts, camshaft holders and holder pipes

on the cylinder head, then tighten the bolts to the

specitied torque.

Specified tolque:

@ - @ : 8 x 1 . 2 5 m m

26 N.m (2.6 kg-m, 19 tb-ft)

@ - @ : 6 x 1 . O m m

1 2 N . m ( 1 . 2 k g - m , I t b - f t )

Seat camshafts by pushing them toward distributor

end ot cylinder head.

Zero dialindicator against end of camshaft. then push

camshaft back and torth and read the end play.

Camshaft End Play:

Standa.d {New): O.O5-O.'1 5 mm

{O.OO2-O.006 in)

S€rvico Limh:

O.5 mm lO.O2 in)

Remove the camshaft holders and holder oiDes

trom the cylinder head.

. Lift camshaft out of cylinder head. wipeclean, then

inspect lift ramps. Replace camshaft if lobes are

pitted, scored, or excessively worn.

. Clean the camshaft holder surfaces in the cylinder

head, then set camshaft back in olace.

a Insert plastigage strip across each journal.

o Install the camshaft holders and holder oiees and

torque bolts to the values and in the sequence

shown in left column.

Troubleshooting