Honda Prelude 1993 Service Manual page 815

Front Suspension
Knuckle/Hub (cont'd)
Removal
4 .
Loosen the wheel nuts slightly.
Raise the Jront of car and support on safety stands
in proper locations {see section 1).
Remove the wheel lug nuts and front wheel.
Raise the locking tab on the spindle nut. then remove
the nut.
Remove the brake hose mounting bolts.
Remove the caliper bracket mounting bolts and hang
the csliper assembly to one side.
CAUTION: To provont accidantal damago to the
calip€r assombly or brako hos€. us€ a short piece ol
wire to hang lhe calipel sgombly from lhe und€r-
cariago.
CAIIP€R ARAO(ET MOUNTING BOLTS
1 2 r 1 . 2 5 m m
6 .
18-12
7 .
8 .
Remove the 6 mm brake disc retaining screws.
Screw two 8 x 1 .25 mm bolts into the disc to push
it away from the hub.
NOTE: Turn each bolt two turns at a time to prevent
cocking the disc excessively.
Remove the b.ake disc from the knuckle.
x 1.25 mm BOLTS
9 .
1 0 .
6 mm SRAKE DISC
RETAINING SCREWS
Remove the wheel sensor wire bracket, then remove
the wheel sensor from the knuckle.
NOTE: Do not disconnect the wheel sensor wire.