Honda Prelude 1993 Service Manual page 135

Timing Belt and Timing Balancer Belt
I
Replacement (cont'd)
Align the g.oove oI the
front driven pulley with
the pointer on the oil
pump housing
21 , Make sure the crankshaft is positioned with the No. 1
piston at TDC.
22, Alignthe groove on the front balancer shaft pulleY with
the pointer on the oil pump housing as shown.
23. Align the rear balancer shaft pulley by using a 6 x 1OO
mm bolt or equivalent as an alignment tool.
Scribe a line 74 mm (2.9 in) Irom the end of the bolt.
lnsertthe boh into the maintenance hole to the scribed
line.
24. Loosen the adjusting nut and verifY that the timing
balancer belt adiuster moves freely.
25. Install the timing balancer belt. Remove the 6 x 1OO
mm bolt from the rear balancer shaft.
26. Tu(n the crankshaft pulleY about one turn counter-
clockwise. then tighten the adiusting nut to the specl-
tied torque.
NOTE: Both belt adiusters are spring-loaded to
properlytension the belts. Do not apply any extra pres-
sure to the pulleYs or tensioners while performing the
adjustment.
REAR BATANCER
R€place.
6 x 100 rm BoLT
12 mm SEALI G AOLT
30 N.m (3.0 kg-m, 22lb-ft)
NOTE: Tighten the bolt after
installing the belt.
ADJUSTING ]{UT
TIMII{G BALAT{CER EELT
BALAI{CER BELT
ORIVE PULLEY
Set the crankshaft
at TDC.
74 mm (2.9 in)
6 r 1OO mm BOLT
6-66
DN|VEIT PULI..EY