Honda Prelude 1993 Service Manual page 361

Fuel Supply System
Fuel Injectors lcont'dl
12. lnstall the tuel injectors and fuel rail assembly in the manifold'
CAUTION:
a To prevent damag€ to ths O{ings, install the lu€l inioctors In th€ fuol rall first. then inslall th€m in tho intaks manifold.
FUEL RAIL
13. Align the center line on the connector with the mark on the Juel rail.
'14, Install
and tighten the retainer nuts.
15. Connect the Juel hose to the fuel rail with new washers.
16. Connect the vacuum hose to the tuel pressure regulator and EGR valve, and the fuel return hose to the tuel pressure
regulator.
17. Install the connectors on the fuel injectors and IAC valve.
18. Replace the 6 mm service bolt washer and tighten the bolt.
19. Turn the ignition switch O N. but do not operate the starter. After the fuel pump runs for approximately two seconds,
the luel pressure in the fuel line rises. Repeat this two or three times, then check whether there is any tuel leakage.
11-120