Honda Prelude 1993 Service Manual page 99

Timing Belt and Timing Balancer Belt
walor pump whon radachg th6
NOTE: Turn the crankshaft so that the No. 1 piston is at
TDC (page 6-28).
I . Remove the splash shield.
.,
Disconnect the connector. then remove the cruise
control actuator.
NOTE:
a Do not disconnect the control cable.
a Take care not to bend the cable when removing the
actuator. Always replace a kinked cable with a new
one.
Replacement .
CAUTION: Inspoct tho
timing b€lt (Pag6 10-12)
CRUISE
ACTUATOR 6 x 1 . O m m
10 t{.m {1.0 kg-m,
7 tb-ttl
SPLASH SHIELD
3. Remove the mounting bolts, nuts and P/S pump belt
from the power steering (P/S) pump.
NOTE:
a Do not disconnect the PiS pipe and hose.
. After installing, adiust the tension of the P/S pump
belt {see section 171.
POWEB
PUMP
STEERING
LOCKNUT
1 5 N . m { 1 . 5 k g - m ,
1 1 tb-ft)
4 .
MOUNTING BO(TS
8 x 1 . 2 5 m m
22 N.m 12.2 kg-m,
1E rb-ftl
P/S PUMP AELT
Disconnect the alternator terminal and the connector,
then removethe engine wire harness from the cvlinder
head cover.
Loosen the alternator mounting bolt/nut and adjusting
bolt, then rernove the altemator belt.
NOTE: After installing, adjust the tension of the alter-
nator bett lsee section 231.
MOUNTIM! EOLT
1 O x 1 . 2 5 m m
4 5 N m { 4 . 5 k g - m ,
33 tb-fr)
ALTENNATOR
AELT
MOUI{TING NUT
8 x 1.25 mm
22 N.m (2.2 kg-m, 16lFft)
(cont'd)
6-29