Honda Prelude 1993 Service Manual page 870

Hide thumbs Also See for Prelude 1993:

Table of Contents

8. Cost a new cup with brake cylinder grease (P/N:

08733-BO2OE) or equivalent rubber grease, and

instalt it with its groove facing the bearing A side of

the adiusting bolt.

9. Fit the bearing A, spacer, adjusting spring B and

spring cover on the adjusting bolt. and install them

in the caliper cylinder.

r:4i!!l!!,il

Install the special tool on the spring cover and tu.n

the shaft until the locknut contacts the olate.

11. Check that the tlared end of the spring cover is

below the circlip groove.

12. Install the circlip in the groove, then remove the

special tool.

NOTE: Check that the circlip is seated in the

groove properly.

13. Coat a new piston seal with silicone grease and in-

stall it in the caliper.

14. Apply brake cylinder grease (P/N: 08733-BO2OE)

or equivalent rubber grease to the sealing lips and

inside of a new piston boot, and install it in the

tzt=-1"=-- "

RUBBER GREASE (cont,d)

Troubleshooting