25, lnstallthe balancer gear case on the oil pump.
NOTE; Align the groove on the pulley edge to the
pointer on the gear case while holding the rear bal-
ancer with the 6 x 100 mm bolt, then install the gear
case.
8 x 1.25 mm
25 N.m 12.5 kg-m, 18 lb-ftl
BALANCER
GEAR CASE
O.FING
Apply 6ngin€ oil.
Replace.
DOWEL PIN
POINTER
Align the O.oove to
pornter,
26. Check alignment of pointers after installing the gear
case.
POINTER ON THE PULLEY
POINTER ON
THE OIL PUMP
DOWEL PIN
GROOVE
27. Install the oil pan.
OIL PAN GASKET
Replace.
Apply liquid
gask€t here.
24.
WASHER
Replac6.
DRAIN EOLT
ils .m 14.5 ks-m, 33 tb_ft)
Do not overtightsn.
Tighten the bolts and nuts as shown below.
Torquo: 12 Nfl (1.2 tg-m,9 lb-ft)
NOTE: Tighten the bolts and nuts in two steps and
torque them in a crisscross pattern.
6 x 1 . 0 m m
a -------_
8 - 1 3