Steering Wheel Installation - Honda Prelude 1993 Service Manual

Hide thumbs Also See for Prelude 1993:

Table of Contents

Steering Wheel

lnstallation

2WS/With SRS:

a B€fore installing the stearing wheel, align the

front wheels straight ahead.

a Be suro to install the ha.ness wires so that they

are not pinched or interfering with other ca.

a Do not replace the original steering wheel with

any othor d€sign, since it will make it impossible

to properly install the airbag. lOnly use gsnuine

HONDA replacement pans)

a Aftel ieassembly, contirm that the wheels are

still straight ahead and that steering wheel

spoke angle is co ect. lf minor spoke angle ad-

iustm€nt is necessary, do so only by adiustment

of tho ti€ rods, not by lemoving and lsposition-

ing the stesring wheel.

conlirm that ths driver's airbag

assembly is socutely attached to lhe steering

whe6l; othorwise, sgvgie personal iniury could

result during airbag dgploYment

1. Before installing the steering wheel, center the

Do this by first rotating the cable reel clockwise un-

til it stops.

Then rotate it counterclockwise (approximately

two turns) until:

- The yellow gear tooth lines up with the align-

ment mark on the cover.

- The arrow mark on the cable reel label points

straight uP.

ALIGNMENT MARK

Install the steering wheel and tighten the steerang

NOTE: Be sure the steering wheel shaft engages

the pins of the cable reel.

STEERING WHEEI

l5.O kg-m, 36 lb-ft)

lnsert the cruise control set/resume swltches con-

nector to the steering wheel clips.

Connect the horn connector.

Troubleshooting