Honda Prelude 1993 Service Manual page 76

Hide thumbs Also See for Prelude 1993:

Table of Contents

Replacement lGylinder head removal not required) (cont'dl

9. Using a downward motion on the l€ve, arm, com-

press the valve spring and remove the keepers from

the valve stem. Slowly release pressure on the

1 O . R e m o v e t h e v a l v e s e a l s ( p a g e 6 - 1 6 ) .

1 1 . Install the valve seals (page 6-21).

12. Install the springs, the retainers and the keepers in

reverse order of removal.

Exhaust Valv6 Seals:

13. Select the 7/8 in. diameter short compressor attach-

ment and lasten the attachment to the No. 4 hole of

the lever arm with the speed pin supplied.

14. Position the lever arm under the cross shaft so the

lever is perpendicular to the shaft and the compressor

attachment rests on top of the retainer for the spring

being compressed. Use the front position slot on the

lever as shown.

NOTE: Put shop towels over the oil passages to pre-

vent the valve keepers from falling into the cylinder

'15. Using a downwatd motion on the levsr arm, com-

press the valve spring and remove the keepers from

the valve stem. Slowly release paessule on the

16. Remove the valve seals (page 6-16).

17. Install the valv€ seals lpage 6-21).

18. Install the springs, the r€tainers 8nd th€ koop€.s in

rgvorso ord€r of romovSl,

19. Repeat steps 6 to 18 on the other cylinde,s.

Troubleshooting