Honda Prelude 1993 Service Manual page 542

Transmission
Removal
. Make Eu16 ltfts. iacks and safoty stands aro placed
properv, 8nd hoist brackots ato attachod to the
corroct positlon on th6 6n9lne (360 soctlon 1).
. Apply psrklng brak6 and Hock roar wheols, so car will
not roll otf stands and ta[ on you while worklng
und6r h.
CAUTION:
Uso f€nder covols to avold damaging paintod surfac€s.
CAUTION:
. A[ SRS olsctrical wi]ing halnossas are covet€d whh
yellow outor insulation.
. Bofore dlsconn€cting the SRS wlro harnoss, install
tho short connoclor (3) on the slrbag ls).
. Reolaco tho entlre affocted SRS ham$s assemHy if
it has an open circuit or damaged wirlng.
NOTE:
The radio mav have I cod€d theft protection circuit. Be
sure to get the customer's code number befole.
- Disconnecting the battery.
- Removing the No.43 (10 Alfuse.
{ln the under-hood fuse/relay boxl
- Removing the radio,
AJter service, reconnect power to the r8dio and turn it
on.
When th€ word
"CODE" is displsyed, enter the
customer's Sdigh code to restore radio operation.
14-80
t .
5 .
Disconnect the battery negative (-) 8nd positive {+)
cables from the battery.
Remov€ the battery set pl8te, then remove the
battery.
Remove the drsin plug, and drain the automatic
transmission lluid (ATFl. Reinstall the drsin plug with a
new sealing washer.
TOROUE:
50 N'm (5.O kem , 36 lb-ft)
DRAIN PLUG
18x 1.5 rrm
50 N.m (5.0 ks-m ,
36 b-ft)
4.
Remove the resonator, intaks air duct and air clesnet
housing.
Disconnect the connectot from the intak€ conttol
vacuum tank, then removs the intake control vacuum
tank 8nd tank bracket.
NOTE:
Do not remove the vacuum tube from the intsko
controlvacuum tank.
AIR CLEAI{ER HOUSIM!
I]YfAKE COi{TROL VACUUM TANK