Honda Prelude 1993 Service Manual page 956

8.
With a spongo, apply a light coat ot glass primer
around the edge of the rear window as shown, then
lightly wipe it off with gauze or cheesecloth.
NOTE:
. Do not apply body primer to the rear window, and
do not get body and glass primer sponges mixed up.
. Never touch the primed surfaces with your hands. lf
you do, the adhesive may not bond to the r6ar
wlndow properly, causing a leak after the rear
window is instslled.
. Keep w8ter, dust, and abrasive materials away trom
the primed surface.
'////z
t apply snrt wl^", hcr..
With a sponoe, apply a light coat oJ body primer to the
original adhesive remalning around the rear window
opening flange. The rear window should be installed 1O
minutes sfter you appV the body primer.
NOTE:
. Do not apply glass primer to the body, snd be
careful not to mix up glass and body primer sponges.
. Never touch the primed surtaces with you. hands.
20 mm
{0.79 in}
9 mm (0.35 inl
LJ
I I
GLAss
f-l | ,/
Ndffi-/
I
RUBEER DAM
9 .
/////t
; Appiv body pdmor horo.
tG mm 10.63lnl 7.4 mm {o.29 in}
1 0 .
1 1 .
Thoroughly mix the 8dhesive and hardener togother on
a glass or m€tal plate with a putty knife. Follow th8
instructions thst came with the adhesive.
NOTE:
Clean I glass or metal plste with s sponge and alcohol
before mixing.
Before filling I cartridge, cut the end of the nozzle as
snown,
Cut nozzle end
as snown.
mm {0.39 In)
7 mm (O,27 In)
Pack adhesive into the csrtridge without 8i. pockets
to ansure continuous delivery. Put the canridge in a
calking gun and run a bead of adhesive around the
edge of the rear window as shown.
NOTE:
Apply the sdhesive within 30 minutes after applying
ths glass prim€r.
2 mm 10.08 in)
12.
ADHESIVE
.'f.ffi,T\
:ADHESIVE
8 m m
(0.31 In)
UPPER
FASTEI{ER
RUAEEB DAM
Mak€ I slightly thicksr
bead at each corner
ano upp9r,
8 m m
1031 In)
(cont'd\
20-23