4Ws Control Unit; Tie-Rod End Boot - Honda Prelude 1993 Service Manual

Removaland Installation
1 .
,
Remove the rear seat back {see section 20}.
Disconnect the terminal wires and connectors f.om
the 4WS control unit.
Remove the 4WS control unit.
-\P
BLK wire.
7 N.m lO.7 kg-m, 5 lb-lt)
RED wire.
BRN wire.
4.
Install in the reverse order of removal.
NOTE: Turn the ignition switch ON and check the
4WS indicator light operation.
4WS CONTROL UNIT
4WS Control Unit Tie-rod End Boot
Replacement
Remove the boot.
Pack the interior of the boot and lip with grease.
Wipe the grease off the sliding surface of the ball
pin, then pack the lower area with lresh grease.
CAUTION:
a Koep groase otl the boot installation s€ction and
th6 tapersd section of the ball pin.
a Do not sllow dust, din, or othar foreign
mat€rials to onter the boot.
2 .
BOOT INSTALLATTON
SECTION
and
BALL PIN TAPERED
SECTION
4 . Install the new balljolnt boot using the special tool
as shown below.
NOTE: After driving the boot onto the ball joint,
apply sealant between the tie-rod end and boot.
TIE.ROD END
CAUTION: After installing the boot, check the ball
pin tapered section fol grease contamination and
wipe it if necossary.
1 7- 1 4 5