Honda Prelude 1993 Service Manual page 611

Throttle ControlCable
Adiustment
NOTE:
Before adjusting the throttle controlcable, make sure that:
. Throttle cable free play is correct (see section 1 1).
. ldle speed is correct (s€e section 1 1).
. You warm up the engine to normal operating temper-
ature (the radiator fan comes on l,
1. Verify thst the throttle linksge is in the fully-closed
oosition.
Loosen the locknut on the throttle control cable at the
throttle control lever.
Remove the free play in the throttle control cable with
the locknut, whil6 pushing the throttle control lav€t to
the tullv-closed Doshion as shown.
THROTTLE COI{TROL LEVEB
Push in this direction.
t-
THROTTLE LINKAGE
1 4 - 1 5 0
4. Tighten the locknuts.
THROTTLE CONTROL LEVER
5. A{ter tightening the locknuts, inspect the synchro-
nization 8nd throttle control lever movemsnt.
NOTE:
To tailor the shift/lock-up characteristics to 8 particular
customer's driving exp€ct8tions, you can adiust the
throttle control cabl€ up to 2mm {0.078 inl shorter thsn tho
"synchronized" point.